Get in touch
News.

Setting up a fully autonomous float.

From case to first sortie in 6 min with a crew of one: how an operator sets up a CF-1212 Eyes, what the float decides on its own, and what it still asks a person for.

A CF-1212 Eyes goes from its case to its first autonomous sortie in 6 min, with one operator and no pilot. This note walks through the setup in the order it happens, with the time each step takes.

Unpack and power on: 1 min 30 s

The operator unfolds the four arms, fits the battery and powers on. The float runs a self-test in 40 s: motors, compass, gimbal and cameras. It will not arm until it holds a GNSS fix on at least 12 satellites.

Set the area and the task: 3 min

On the ground station tablet, the operator draws the area to observe or picks a saved one. Then the task: hold a view of one point, or patrol one line. A ceiling of 120 m is set by default and can only be lowered.

Airspace is the operator's job. The ground station shows the controlled airspace nearby, but authorisation to fly stays with the person who launches.

What the float decides

From there, the float plans its route and flies it. That is what autonomous means here: no pilot in the loop.

  • It picks a holding position upwind of the point it watches, so a gust carries it toward the view, not away.
  • It corrects for wind up to 10 m/s without being asked.
  • It returns to base when its battery reaches 25%, or when its GNSS fix drops below 8 satellites.
  • It lands within 1.5 m of its launch point.

What it still asks a person for

Three things. It asks the operator to confirm the launch. It asks again if its landing point is blocked when it returns, and offers a second point. And it hands over control when the operator takes it: manual mode is remote-piloted, and the spec sheet names it as such.

Conditions for this setup

  • Wind: up to 10 m/s.
  • Temperature: −10 °C to 40 °C.
  • Light: day or night; at night the thermal camera leads.
  • Setup time: 6 min, measured from case closed to wheels up, over 40 setups by trained operators.

The first setup takes longer. By the tenth, operators in our tests were inside 6 min.

Set the area. Set the task. Then step back. The float should need you less with every sortie.

More.

Read all9